The specifications in this standard make sites, facilities, buildings and elements accessible to and usable by people with such physical disabilities as the inability . 31 Jul LEGALLY BINDING DOCUMENTUnited States of AmericaAll citizens and residents are hereby advised that this is a legally binding document. Trademarks: “ICC,” the International Code Council logo and “Accessible and Usable Buildings and Facilities (ICC/ANSI Al )” are trademarks of the.
|Published (Last):||18 May 2006|
|PDF File Size:||18.7 Mb|
|ePub File Size:||10.57 Mb|
|Price:||Free* [*Free Regsitration Required]|
Central to the intent of the change in the Secretariat was the development of a standard that, when adopted as part 2003 icc ansi a117.1 a building code, would be compatible with the building code and its enforcement. Controls and hand showers shall comply with Sections Swing-up grab bars shall comply with Sections In des- tination-oriented elevators, a display 20033 be provided in 2003 icc ansi a117.1 car with visible indicators to show car destinations.
Passenger loading zones shall provide a vehicular pull-up space 96 2003 icc ansi a117.1 mm minimum in width and 20 feet mm minimum in length. Function keys shall comply with Section One full, unobstructed side of the clear floor space shall adjoin or overlap an accessi- ble route or adjoin another clear floor space.
Space beneath an element between the snsi and 9 inches mm above the floor shall be considered toe clearance and shall comply with Section Where existing building floor designa- tions differ from the arrangement required by Section 2003 icc ansi a117.1 The receiver shall be designed for a high dynamic range and capable of operating in full-sun back- ground illumination.
ICC/ANSI A – (Accessible and Usable Buildings and Facilities)
The height of bathtub seats shall be 17 inches mm minimum to 19 inches mm maximum above the bathroom floor, measured to the top of the seat. 2003 icc ansi a117.1 signals are not required to comply with the requirement for 2003 icc ansi a117.1 audible tones.
Access aisles shall not overlap the vehicular way. Detectable warnings shall be 24 inches mm minimum in the direction of travel and extend the 22003 width of the curb ramp or flush surface. Absi shall be uppercase. Urinals shall be of the stall type or shall be of the wall hung type with the rim at 17 inches mm maximum above the floor.
Destination-oriented elevators shall not be required to comply with Sec- tion Visual 2003 icc ansi a117.1 shall be 40 inches mm minimum above the floor of the viewing position, measured to the baseline of the character. The reopening device shall not require physical contact to be acti- vated, although contact shall be permitted before the door reverses.
2003 ICC Accessible and Usable Buildings and Facilities
Doors and doorways that are part of an accessible route shall comply with Section The clear adjoining surface maximum slope curb ramp maximum Sl Counter Sliope Fig. Handrails shall extend beyond qnsi in the same direction of stair flights and ramp runs in accordance with Section A walking surface that has a running slope steeper than 2003 icc ansi a117.1 Signs s117.1 elevator hoistways shall comply with Section Distribution of the PDF is not permitted.
An accessible route with a clear width less than 60 2003 icc ansi a117.1 mm shall provide passing spaces at intervals of feet 61 m maximum. Without advance written permissionfrom the copyright owner, no part of this book may be reproduced, distributed, or transmitted in any form or by any means, including, without limitation, electronic, optical or mechanical means by way of example, and not limitation, photocopying, or ansii by or in an information storage retrieval system.
ANSI A117.1 (2003): Accessible and Usable Buildings and Facilities
Characters shall 2003 icc ansi a117.1 uppercase, lowercase, or a combination of both. Clear floor space is not required at drive up only automatic teller machines and fare machines. Where accessible parking spaces are required to be identified by signs, the signs shall include the International A1117.1 of Accessibility complying with Section Wheelchair spaces and wheel chair space locations in assembly areas with spectator seating shall comply with Section Car 2003 icc ansi a117.1 shall provide a clear opening width of 32 inches mm minimum.
Where separate tactile and visual characters with the same information are provided, the height of the 2003 icc ansi a117.1 upper- case letter “I” shall be permitted to be V 2 inch 13 mm minimum.
The permitted projection of the nosing shall be 1 V 2 inches 38 mm maximum over the tread or floor below. Elevator car leveling shall comply with Section A clearance of 48 inches 1 mm minimum in length measured perpen- dicular from the control wall, and 36 inches mm minimum in depth shall be provided adja- cent to the open face of the compartment.
An adjustable-height hand shower mounted on anis verti- cal bar shall be installed so as to not obstruct the use 2003 icc ansi a117.1 grab bars.
Where handrails are required at the side of a corridor they shall comply with Sec- tions The clear floor space adjacent to the control switch shall be located beyond 2003 icc ansi a117.1 arc of the door swing.
Unless otherwise specified, clear floor space shall be permitted to include knee and toe clearance complying with Section Assistive listening systems shall be identified by the International Symbol of Access for Hearing Loss complying with Figure Detectable warning surfaces shall 2003 icc ansi a117.1 visually with adjacent surfaces, either light-on-dark or dark-on-light.
Table of Contents | ICC publicACCESS
Building Blocks a Forward b Parallel Fig. Signs with tactile characters shall be permitted on the push side of doors with closers and without hold-open devices. For elevators with a car that has more than one opening, the hoistway doors and gates shall be permitted to be of the man- ual-open, self-close type. A1171 of accessibility shall comply with Section Symbols of acces- sibility and their backgrounds shall have a nonglare finish.
Seats shall comply absi Section ‘ For infor- mation onpermission to copy 2003 icc ansi a117.1 exceeding fair use, please contact: Control buttons shall be identified by tactile characters complying with Ixc Cavities created by 2003 icc ansi a117.1 kick plates shall be capped. Doors that do not extend to within 10 inches mm of the floor.
Toe clearance shall be permitted to extend 25 inches mm maxi- mum under an element. Knee occ shall be 30 inches mm minimum in width.